etel opensuse einwahl

Das Forum fĂĽr den Linux-Pinguin - auch andere Unix-Derivate (*BSD, (Open)Solaris, Apple's Darwin / MacOS X, ...) sind hier willkommen!
Forumsregeln
Das Forum fĂĽr den Linux-Pinguin - auch andere Unix-Derivate (*BSD, (Open)Solaris, Apple's Darwin / MacOS X, ...) sind hier willkommen!

Beitragvon lordpeng » Sa 28 Jul, 2007 13:20

na geht doch, und welchen dsl anschluss hast du? business? privat? sonstwas? dem modem nach dĂĽrfts wohl ein privat anschluss sein und da du bei etel bist brauchst du pptp, pppoe gibts bei privat accounts nur bei entbĂĽndelten anschlĂĽssen
lordpeng
Moderator
Moderator
 
Beiträge: 10183
Registriert: Mo 23 Jun, 2003 22:45

Beitragvon nerd » Sa 28 Jul, 2007 13:57

aslo PPTP eingeestellt (obwohl der der den rechner voher PPPOE empfohlen hat.
DHCP

und folgende logs

ifconfig

eth0 Link encap:Ethernet HWaddr 00:02:44:16:A7:3E
inet addr:85.90.133.195 Bcast:255.255.255.255 Mask:255.0.0.0
inet6 addr: fe80::202:44ff:fe16:a73e/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:40 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:2676 (2.6 Kb)
Interrupt:9 Base address:0xae00

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:138 errors:0 dropped:0 overruns:0 frame:0
TX packets:138 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:8924 (8.7 Kb) TX bytes:8924 (8.7 Kb)

sit0 Link encap:IPv6-in-IPv4
NOARP MTU:1480 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)

Iptablea

Chain INPUT (policy ACCEPT)
target prot opt source destination

Chain FORWARD (policy ACCEPT)
target prot opt source destination

Chain OUTPUT (policy ACCEPT)
target prot opt source destination

messages

Jul 28 14:41:51 linux-p5nr dhcdbd: Started up.
Jul 28 14:41:52 linux-p5nr kernel: eth0: link up, 100Mbps, full-duplex, lpa 0x41E1
Jul 28 14:42:04 linux-p5nr kernel: eth0: no IPv6 routers present
Jul 28 14:42:04 linux-p5nr pppd[3835]: Plugin rp-pppoe.so loaded.
Jul 28 14:42:04 linux-p5nr pppd[3835]: RP-PPPoE plugin version 3.3 compiled against pppd 2.4.4
Jul 28 14:42:04 linux-p5nr pppd[3835]: Plugin passwordfd.so loaded.
Jul 28 14:42:04 linux-p5nr pppd[3835]: pppd 2.4.4 started by root, uid 0
Jul 28 14:42:41 linux-p5nr pppd[3835]: Timeout waiting for PADO packets
Jul 28 14:42:41 linux-p5nr pppd[3835]: Unable to complete PPPoE Discovery
Jul 28 14:42:41 linux-p5nr pppd[3835]: Exit.
Jul 28 14:43:58 linux-p5nr pppd[3871]: Plugin rp-pppoe.so loaded.
Jul 28 14:43:58 linux-p5nr pppd[3871]: RP-PPPoE plugin version 3.3 compiled against pppd 2.4.4
Jul 28 14:43:58 linux-p5nr pppd[3871]: Plugin passwordfd.so loaded.
Jul 28 14:43:58 linux-p5nr pppd[3871]: pppd 2.4.4 started by root, uid 0
Jul 28 14:44:36 linux-p5nr pppd[3871]: Timeout waiting for PADO packets
Jul 28 14:44:36 linux-p5nr pppd[3871]: Unable to complete PPPoE Discovery
Jul 28 14:44:36 linux-p5nr pppd[3871]: Exit.
Jul 28 14:44:52 linux-p5nr pppd[3895]: Plugin rp-pppoe.so loaded.
Jul 28 14:44:52 linux-p5nr pppd[3895]: RP-PPPoE plugin version 3.3 compiled against pppd 2.4.4
Jul 28 14:44:52 linux-p5nr pppd[3895]: Plugin passwordfd.so loaded.
Jul 28 14:44:52 linux-p5nr pppd[3895]: pppd 2.4.4 started by root, uid 0
Jul 28 14:45:30 linux-p5nr pppd[3895]: Timeout waiting for PADO packets
Jul 28 14:45:30 linux-p5nr pppd[3895]: Unable to complete PPPoE Discovery
Jul 28 14:45:30 linux-p5nr pppd[3895]: Exit.

netstat

Kernel IP routing table
Destination Gateway Genmask Flags MSS Window irtt Iface
85.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 eth0
127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo


kinternet.log

SuSE Meta pppd (smpppd-ifcfg), Version 1.59 on linux-p5nr.
Status is: disconnected
trying to connect to smpppd
connect to smpppd
Status is: disconnected
Interface is eth0.
Status is: connecting
pppd[0]: Plugin rp-pppoe.so loaded.
pppd[0]: RP-PPPoE plugin version 3.3 compiled against pppd 2.4.4
pppd[0]: Plugin passwordfd.so loaded.
pppd[0]: Timeout waiting for PADO packets
Timeout Waiting for PADO packets. Check your setup and cables and try again.
pppd[0]: Unable to complete PPPoE Discovery
Status is: disconnected
pppd[0] died: Connection terminated at peer's request (exit code 0)


TIA
lg
nerd
Zuletzt geändert von nerd am Sa 28 Jul, 2007 14:06, insgesamt 1-mal geändert.
nerd
Neu im Board
Neu im Board
 
Beiträge: 11
Registriert: Mo 23 Jul, 2007 15:21

Beitragvon nerd » Sa 28 Jul, 2007 14:05

lordpeng hat geschrieben:dem modem nach dĂĽrfts wohl ein privat anschluss sein


genau... Privat
lg
nerd
nerd
Neu im Board
Neu im Board
 
Beiträge: 11
Registriert: Mo 23 Jul, 2007 15:21

Beitragvon penguinforce » So 29 Jul, 2007 02:02

hint: wenn du pptp verwenden sollst, warum steht in den logs immer noch was von pppoe? ;)

10.0.0.140 sollte dein rechner von dir zugewiesen bekommen, der pptp-tunnel wird auf 10.0.0.138 (speedtouch) aufgebaut.

lösch deine jetzige internetverbindung, stell die netzwerkkarte richtig ein, und wähl bei susi einfach aon als provider aus...

sollte normalerweise funktionieren.

:diabolic:
penguinforce
 

Beitragvon nerd » So 29 Jul, 2007 10:30

penguinforce hat geschrieben:lösch deine jetzige internetverbindung, stell die netzwerkkarte richtig ein, und wähl bei susi einfach aon als provider aus...

sollte normalerweise funktionieren.

:diabolic:


Das wars, Thanks,Thanks,Thanks,Thanks,Thanks,Thanks,Thanks,Thanks,
lg
nerd
PS.: Thanks again!
nerd
Neu im Board
Neu im Board
 
Beiträge: 11
Registriert: Mo 23 Jul, 2007 15:21

Vorherige

ZurĂĽck zu LINUX & UNIX-DERIVATE

Wer ist online?

Mitglieder in diesem Forum: 0 Mitglieder und 28 Gäste